How Tungsten Wire is Made

Looking to purchase tungsten wire? View our wire selection.

Making tungsten wire is a complex, difficult process. The process must be tightly controlled in order to insure the proper chemistry as well as the proper physical properties of the finished wire. Cutting corners early in the process to reduce wire prices can result in poor performance of the finished product. You can be confident that wire from MTS has been consistently manufactured to the highest standards and will perform consistently well.

Refining tungsten from ore cannot be performed by traditional smelting since tungsten has the highest melting point of any metal. Tungsten is extracted from ore through a series of chemical reactions. The exact process varies by manufacturer and ore composition, but ores are crushed then roasted and/or sent through a variety of chemical reactions, precipitations, and washings to obtain ammonium paratungstate (APT). APT can be sold commercially or further processed to tungsten oxide. Tungsten oxide can be roasted in a hydrogen atmosphere to create pure tungsten powder with water as a by-product. Tungsten powder is the starting point for tungsten mill products, including wire.

Now that we have pure tungsten powder, how do we make wire?

1. Pressing

Tungsten powder is sifted and mixed. A binder may be added. A fixed amount is weighed and loaded into a steel mold which is loaded into a press. The powder is compacted into a cohesive, yet fragile bar. The mold is taken apart and the bar removed.

2. Presintering

The fragile bar is placed into a refractory metal boat and loaded into a furnace with a hydrogen atmosphere. The high temperature begins to consolidate the material together. Material is about 60% – 70% of full density, with little or no grain growth.

3. Full Sintering

Bar is loaded into a special water-cooled treating bottle. Electric current will be passed through the bar. The heat generated by this current will cause the bar to densify to about 85% to 95% of full density and to shrink by 15% or so. Additionally, tungsten crystals begin to form within the bar.

4. Swaging

The tungsten bar is now strong, but very brittle at room temperature. It can be made more malleable by raising its temperature to between 1200°C to 1500°C. At this temperature, the bar can be passed through a swager. A swager is a device which reduces the diameter of a rod by passing it through a die which is designed to hammer the rod at about 10,000 blows per minute. Typically a swager will reduce the diameter by about 12% per pass. Swaging elongates the crystals, creating a fibrous structure. Although this is desirable in the finished product for ductility and strength, at this point the rod must be stress-relieved by reheating. Swaging continues until the rod is between .25 and .10 inches.

5. Drawing

Swaged wire of about .10 inches can now be drawn through dies to reduce the diameter. 

A wire is lubricated and drawn through dies of tungsten carbide or diamond. 

The exact reductions in diameter depends on the exact chemistry and the final use of the wire. As the wire is drawn, fibers again elongate and tensile strength increases. At certain stages, it may be necessary to anneal the wire to allow further processing. A wire can be drawn as fine as .0005 inches in diameter.

This is a simplification of a complex, tightly-controlled process. If you need more detailed information or have any questions please contact us.

How much does Tungsten Wire cost?

Looking to purchase tungsten wire? Check out our online wire selection!